African Satellite World and Sat Gear

African Satellite World and Sat Gear

This E! nt*mnt is calling for an autoroll box, another change in a week!!!
 
Gich said:
More testing: after the successful 4x1-to-8x1 diseqc-to-2x1 splitter-to-2 stbs testing, I embarked on testing if one can receive other channels on the Az*m stb. Armed with an 8x1 diseqc switch using the disceqc 1.1 settings on the receiver, I used diseqc 1.1. I tested with about 4 birds. The results were impressive with both C & KU bands, but unfortunately the receiver is not pvu compliant. Hower, the stb was able to receive the non-pvu channels on C. I hence dropped the C bands and concentrated on KUs.
Here are some of the pictures of the results:

The settings on the stb
View attachment 438810 View attachment 438811 View attachment 438812

The results
View attachment 438813 View attachment 438814 View attachment 438815 View attachment 438817
Click to expand...
how u open azam channels?how did u use 1 out disec to 2 stbs plz
 
Gich said:
SRT4950H_V4.04p Dated Nov 17th 2016: Summary of my findings:

• Solving for identified bugs after release of the one dated October 21, 2016
• Is able to autoroll all the pvu keys on NSS*_12, IS20 and Ap7 (except 3920H 28340 on AP7) the earlier version did not autoroll most of the pvu keys on these satellites.
• Still not able to autoroll the above tp carrying the A-eX-eN and SQny mux on AP7 hence a manual key input required
• Autorolled these keys after 10 minutes on average.
• Retains the same light bluish theme that has come to be identified with 4950H lately
• All channels stable at sufficient signal levels (Q78% and above)
NB: back up your channel list and remember to factory reset your receiver after the SW update
Click to expand...
I have also upgraded 4950h today with v 4.04 and then did factory setting but it was not autorolling after leaving it for more than 20 minutes.I had to manual put the keys for 68.5 satellite.But the challenge was for HD 24 of 57 degree satellite, I gave it time to autoroll maybe but no success. Am thinking of downgrading to v 3.58 which was working very well.This was my observation.Has anybody encountered the same?
 
colesbergkhn said:
how u open azam channels?how did u use 1 out disec to 2 stbs plz
Click to expand...
  • Opening Az*m channels: this is a pay TV, so the only way to open them is to pay for a sub. My interest was to try to see if the stb can get other channels besides the paid ones.
  • How to use 1 diseqc out to 2 stbs: this was an experiment I did and shared the results here. I used a 1x2 splitter to split the signal to the 2 stbs. I hope I have answered you.
 
Kitengi said:
I have also upgraded 4950h today with v 4.04 and then did factory setting but it was not autorolling after leaving it for more than 20 minutes.I had to manual put the keys for 68.5 satellite.But the challenge was for HD 24 of 57 degree satellite, I gave it time to autoroll maybe but no success. Am thinking of downgrading to v 3.58 which was working very well.This was my observation.Has anybody encountered the same?
Click to expand...
I also did upgrade mine and the autoroll wasn't working either I had to downgrade to 3.58.
 
Hi fellow FTA enthusiasts, is there any hope of getting SRT4922 Auto-roll patch?
 
Gich said:
Check my post on page 1087.
Click to expand...
ok i c it,, but tell me i have intelsat 20 c plus ku,,, ses5east..eutelsat7east..paksat1r 38east c band,,, the way u have done it its working well then i think i must try it,,, bcoz now i m using dual lnbs c band n ku band for my 2stbs,,bcoz i m afraid that if i use 2by1 splitter may b if we r watching both stbs then 1stb not gona respond well,,what do u think?
 
Kitengi said:
I have also upgraded 4950h today with v 4.04 and then did factory setting but it was not autorolling after leaving it for more than 20 minutes.I had to manual put the keys for 68.5 satellite.But the challenge was for HD 24 of 57 degree satellite, I gave it time to autoroll maybe but no success. Am thinking of downgrading to v 3.58 which was working very well.This was my observation.Has anybody encountered the same?
Click to expand...
On my side it autorolls most tps only a few don't ..... also, HD 24 autorolls faster than before.
 
Vicwa said:
On my side it autorolls most tps only a few don't ..... also, HD 24 autorolls faster than before.
Click to expand...
Hi forum members,any member from uganda locked on Yahsat 1A especially east beam.I wish to hear from you.
 
I have managed to combine 70b and 68.5e KU using one lnb on 90cm offset. Signal quality for KTN on 70 is 70% and N%BCu is 60%
 
Gich said:
More testing: after the successful 4x1-to-8x1 diseqc-to-2x1 splitter-to-2 stbs testing, I embarked on testing if one can receive other channels on the Az*m stb. Armed with an 8x1 diseqc switch using the disceqc 1.1 settings on the receiver, I used diseqc 1.1. I tested with about 4 birds. The results were impressive with both C & KU bands, but unfortunately the receiver is not pvu compliant. Hower, the stb was able to receive the non-pvu channels on C. I hence dropped the C bands and concentrated on KUs.
Here are some of the pictures of the results:

The settings on the stb
View attachment 438810 View attachment 438811 View attachment 438812

The results
View attachment 438813 View attachment 438814 View attachment 438815 View attachment 438817
Click to expand...
sorry i need all frequency that you save to get free channel
 
You must log in or register to reply here.

Similar Discussions

Our Community

Coming Soon

Regional Communities

Coming Soon
Back
Top Bottom
Menu
Forums
New posts
Log in
Register